Home » Sponsored » Pi Speakers » Excited =)
Re: Excited =) [message #68486 is a reply to message #68256] Tue, 05 July 2011 23:37 Go to previous messageGo to previous message
Dave_S is currently offline  Dave_S
Messages: 28
Registered: April 2011
Chancellor
You made really quick progress on those. They look good.

As far as the gaskets, what Wayne said should work. I took Wayne's advice from a previous post about using a shower liner gasket from Home Depot. That seems to work well also.

I know that you said that you said that you are considering options for finishing. From what I have seen of your design, I would recommend a 2 ply veneer if you decide to finish them with a wood veneer. I (stupidly) decided to use strips of wood veneer and splice them together myself. I did that a long time ago when stock veneer was thicker and it worked well. To replace what I screwed up, I bought a 2 ply veeneer. It was very stable and not prone to wrinkling or bubbles. I wish the entire covering of my speakers were covered with 2 ply veneer. I put the final sheet of my spliced veneer on this weekend. There is no photographic evidence of the botched attempt.
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: PI4 Build for home theatre
Next Topic: Any Pi builders in Ireland ?
Goto Forum:
  


Current Time: Thu Nov 21 17:47:25 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest