AudioRoundTable.com: Pi Speakers » Rabbet dimensions for flush mounting (4Pi upgraded)

Home » Sponsored » Pi Speakers » Rabbet dimensions for flush mounting (4Pi upgraded) (Flush Mounting)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Rabbet dimensions for flush mounting (4Pi upgraded) [message #66981 is a reply to message #66975]

Sun, 10 April 2011 19:34

blvdre
Messages: 35
Registered: April 2010
Location: Burlington, VT

Baron

Thanks Wayne. So do I need to add to the woofer OD so that it will seat properly? In other words, If the rabbet is as wide as the woofer OD, will it seat OK? I see the horn is a bit harder to pin down, so I will plan accordingly and leave a little wiggle room.

Report message to a moderator

[Message index]

		Rabbet dimensions for flush mounting (4Pi upgraded) By: blvdre on Sun, 10 April 2011 08:58
		Re: Rabbet dimensions for flush mounting (4Pi upgraded) By: Wayne Parham on Sun, 10 April 2011 12:45
		Re: Rabbet dimensions for flush mounting (4Pi upgraded) By: blvdre on Sun, 10 April 2011 19:34
		Re: Rabbet dimensions for flush mounting (4Pi upgraded) By: Wayne Parham on Sun, 10 April 2011 23:17
		Re: Rabbet dimensions for flush mounting (4Pi upgraded) By: blvdre on Mon, 11 April 2011 05:41

Previous Topic:	It's Here! T-2020 Chip Amp
Next Topic:	Three Pi & Four Pi Plans

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 23 01:10:35 CST 2024