AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » 4 pi, oh my! (pi 4)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 4 pi, oh my! [message #66246 is a reply to message #66242]

Mon, 21 February 2011 22:41

Matts
Messages: 359
Registered: May 2009

Grand Master

Ok, what kind of drivers in them? xover? do you plan to put some veneer on them?

"lack of compression" haha!! these speakers ARE dynamic...

I use them with 3.5 watt SET and they work great. With the Cary's you'll get some definite pop.

Report message to a moderator

[Message index]

		4 pi, oh my! By: EL Jack on Mon, 21 February 2011 18:14
		Re: 4 pi, oh my! By: Wayne Parham on Mon, 21 February 2011 19:07
		Re: 4 pi, oh my! By: EL Jack on Mon, 21 February 2011 19:38
		Re: 4 pi, oh my! By: Matts on Mon, 21 February 2011 22:41
		Re: 4 pi, oh my! By: EL Jack on Tue, 22 February 2011 12:48
		Re: 4 pi, oh my! By: Wayne Parham on Tue, 22 February 2011 13:53
		Re: 4 pi, oh my! By: Bill Epstein on Tue, 22 February 2011 17:10
		Re: 4 pi, oh my! By: steve f on Wed, 23 February 2011 02:41
		Re: 4 pi, oh my! By: Bill Epstein on Wed, 23 February 2011 08:45
		Re: 4 pi, oh my! By: Wayne Parham on Wed, 23 February 2011 14:25
		Re: 4 pi, oh my! By: Matts on Wed, 23 February 2011 14:45
		Re: 4 pi, oh my! By: EL Jack on Wed, 23 February 2011 09:55
		Re: 4 pi, oh my! By: Bill Epstein on Wed, 23 February 2011 21:29
		Re: 4 pi, oh my! By: Matts on Tue, 22 February 2011 17:09
		Re: 4 pi, oh my! By: Psychoacoustic on Wed, 23 February 2011 21:45
		Re: 4 pi, oh my! By: Doc Jr 8156 on Thu, 24 February 2011 22:05
		Re: 4 pi, oh my! By: vinylvalet on Mon, 29 August 2011 08:56
		Re: 4 pi, oh my! By: Wayne Parham on Mon, 29 August 2011 09:57
		Re: 4 pi, oh my! By: vinylvalet on Tue, 30 August 2011 08:21
		Re: 4 pi, oh my! By: Wayne Parham on Tue, 30 August 2011 08:43
		Re: 4 pi, oh my! By: vinylvalet on Tue, 30 August 2011 09:29
		Re: 4 pi, oh my! By: Wayne Parham on Tue, 30 August 2011 13:10

Previous Topic:	4Pi Speaker Plans request
Next Topic:	crossover board assembly

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 22 00:46:12 CST 2024