AudioRoundTable.com: Pi Speakers » DI-matched two-way loudspeakers

Home » Sponsored » Pi Speakers » DI-matched two-way loudspeakers (Lobes and nulls, crossover phase and baffle spacing, revisited)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Lobes and nulls, crossover phase and baffle spacing [message #61466 is a reply to message #61455]

Wed, 25 November 2009 02:14

Norris Wilson
Messages: 361
Registered: May 2009

Grand Master

Wayne,

What a great compilation of information about crossover design and DI matching in a two-way speaker using a horn and compression driver for a tweeter.

Obviously, this has taken many hours, even years to gain such knowledge where it could be offered here.

It is an act of selfless devotion to the DIY speaker building community to present this information, a passion.

I thank you for such passion and sharing of your time and knowledge.

This has enriched all of us here who enjoy your offerings.

Norris

Report message to a moderator

[Message index]

		DI-matched two-way loudspeakers By: Wayne Parham on Mon, 23 November 2009 14:38
		Re: Lobes and nulls, crossover phase and baffle spacing By: Norris Wilson on Wed, 25 November 2009 02:14
		Re: Lobes and nulls, crossover phase and baffle spacing By: Matts on Wed, 25 November 2009 09:23
		Re: Lobes and nulls, crossover phase and baffle spacing By: Wayne Parham on Thu, 26 November 2009 19:40
		Re: Lobes and nulls, crossover phase and baffle spacing By: Wayne-o on Thu, 26 November 2009 20:47
		Re: Lobes and nulls, crossover phase and baffle spacing By: Wayne Parham on Thu, 26 November 2009 21:37

Previous Topic:	Don't forget to check under the hood
Next Topic:	4 pi plans

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Feb 25 21:07:52 CST 2025