Re: Back loaded corner horn [message #52967 is a reply to message #52961] |
Mon, 15 December 2008 15:01   |
xsheaffer
Messages: 6 Registered: May 2009
|
Esquire |
|
|
Wayne, I remember in one of your tutorial papers (which I cannot seem to locate...GRRRRR), there was a factor used to calculate the spacing from the wall that I don't understand. IIRC it used a quantity "V" times sqrt 3, but I don't recall. Old age I guess... The back loaded 1 driver approach is a little different than your Pi implementation, but I want to employ the same approach using a coupling chamber for the backwave of the one driver. The trouble is I don't have a very good understanding of the design parameters of the Pi corner horn! I am just getting started. Wayne, could you steer me toward more info? Much appreciated any help you could provide! Thanks!
|
|
|