AudioRoundTable.com: Pi Speakers » Question about completed crossovers

Home » Sponsored » Pi Speakers » Question about completed crossovers

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Update, Update!!! Crossover early impressions [message #52327 is a reply to message #52324]

Tue, 15 July 2008 13:46

Matts
Messages: 359
Registered: May 2009

Grand Master

Wayne, I've got the older xover, w/ just a 0.7mH coil on the 2226, and the Eminence style for the comp driver- 8.0 cap, 0.65mH coil, etc. My coils are humongous North Creek custom-wound, and I was wondering if there's any change I could make to add to this or substitute a cap to get some improvement w/out starting all over.

Although, I may just start over at some point if need be....however, I'm not in any way unhappy with my current sounds, so I don't NEED to do anything...but...

Report message to a moderator

[Message index]

		Question about completed crossovers By: Bill Epstein on Sat, 12 July 2008 06:46
		Re: Question about completed crossovers By: Wayne Parham on Sat, 12 July 2008 11:51
		Re: Question about completed crossovers By: Bill Epstein on Sat, 12 July 2008 19:42
		Re: Question about completed crossovers By: Wayne Parham on Sat, 12 July 2008 19:52
		Re: Update, Update!!! Crossover early impressions By: Bill Epstein on Mon, 14 July 2008 17:16
		Re: Update, Update!!! Crossover early impressions By: Wayne Parham on Mon, 14 July 2008 19:47
		Re: Update, Update!!! Crossover early impressions By: Matts on Tue, 15 July 2008 13:46
		Re: Update, Update!!! Crossover early impressions By: Wayne Parham on Thu, 17 July 2008 22:54
		Re: Update, Update!!! Crossover early impressions By: Matts on Fri, 18 July 2008 00:33
		Re: Update, Update!!! Crossover early impressions By: Kim Schultz on Wed, 16 July 2008 04:31
		four π crossover By: Wayne Parham on Wed, 16 July 2008 14:22
		Re: four π crossover :-) By: Bill Epstein on Wed, 16 July 2008 22:19

Previous Topic:	4Pi horn
Next Topic:	2226 Box size questions, or, where're my ears?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 04:13:33 CST 2024