AudioRoundTable.com: Pi Speakers » Crossover update and a monster recording

Home » Sponsored » Pi Speakers » Crossover update and a monster recording

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 95 bucks doesn't buy that much flexibility [message #52259 is a reply to message #52258]

Sun, 29 June 2008 20:32

Bill Epstein
Messages: 1088
Registered: May 2009
Location: Smoky Mts. USA

Illuminati (2nd Degree)

It just has the high pass and it's a 4th order L-W.

The darn 16ohm woofer means huge coils and the parts for the board run to $200 so it'll be a few weeeks until I can order them. Looking forward to it.

***The little dials on the ART tell me I'm near 14dB attenuation but I can't be sure. 14dB wasn't quite right with the old passive crossover. What can be done to tweak it a bit w/o going to the full next step down? 15 and 30 ohms with a .22cap, perhaps? Something else?***

Report message to a moderator

[Message index]

		Crossover update and a monster recording By: Bill Epstein on Sun, 29 June 2008 18:30
		Active crossover settings By: Wayne Parham on Sun, 29 June 2008 19:35
		Re: 95 bucks doesn't buy that much flexibility By: Bill Epstein on Sun, 29 June 2008 20:32
		Re: 95 bucks doesn't buy that much flexibility By: Wayne Parham on Sun, 29 June 2008 20:48
		Re: 95 bucks doesn't buy that much flexibility By: Bill Epstein on Sun, 29 June 2008 23:12
		Re: 95 bucks doesn't buy that much flexibility By: Wayne Parham on Mon, 30 June 2008 00:14
		Re: 95 bucks doesn't buy that much flexibility By: spkrman57 on Wed, 02 July 2008 10:20
		Re: Crossover update and a monster recording By: Matts on Sun, 29 June 2008 21:20
		Re: Crossover update and a monster recording By: Bill Epstein on Mon, 30 June 2008 19:22

Previous Topic:	8 Pi x-over ?
Next Topic:	Headphones with smooth freq.

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 23 12:08:05 CST 2024