AudioRoundTable.com: Pi Speakers » Wayne, crossover and L-pad confusion

Home » Sponsored » Pi Speakers » Wayne, crossover and L-pad confusion

Wed, 27 February 2008 07:04

Kim Schultz
Messages: 85
Registered: May 2009

Viscount

I did some measurements today, see below:

The most flat is the one using the C2=8.2uF, but it does not look as much like the standard crossover, as the one using C2=10uF.

Is the reason for the peaking response around 1800hz, to compensate for the falling response of the midhorn ?

		Wayne, crossover and L-pad confusion By: Bill Epstein on Sun, 24 February 2008 14:48
		Top octave augmentation for compression horn tweeters By: Wayne Parham on Sun, 24 February 2008 16:54
		Re: OK, I'll quit re-inventing the wheel By: Bill Epstein on Sun, 24 February 2008 17:18
		Never! By: Wayne Parham on Sun, 24 February 2008 18:05
		Re: Pi Align strikes again! By: Bill Epstein on Tue, 26 February 2008 04:58
		Re: Upon further review By: Bill Epstein on Tue, 26 February 2008 12:10
		Re: Upon further review By: Wayne Parham on Wed, 27 February 2008 11:55
		What about 16ohm drivers By: Kim Schultz on Tue, 26 February 2008 14:18
		Correction By: Kim Schultz on Wed, 27 February 2008 03:40
		Now with measurements. By: Kim Schultz on Wed, 27 February 2008 07:04
		Re: Now with measurements. By: Wayne Parham on Wed, 27 February 2008 12:48
		Spice rules ;-) By: Kim Schultz on Wed, 27 February 2008 14:03
		Re: Spice rules ;-) By: Wayne Parham on Wed, 27 February 2008 14:22
		Re: Spice rules ;-) By: Kim Schultz on Wed, 27 February 2008 15:07
		Re: Spice rules ;-) By: Wayne Parham on Wed, 27 February 2008 18:49

Previous Topic:	Mounting Eminence Driver
Next Topic:	midbass horn

Goto Forum:

] [

]

Current Time: Tue Nov 26 12:50:47 CST 2024