AudioRoundTable.com: Pi Speakers » Wayne, crossover and L-pad confusion

Home » Sponsored » Pi Speakers » Wayne, crossover and L-pad confusion

Wed, 27 February 2008 03:40

Kim Schultz
Messages: 85
Registered: May 2009

Viscount

I just had a look at the crossovers today and I didn´t remember all to values correct, this is the values I´m using:

C1 = 0.47uF
C2 = 10uF
R1 = 11ohm
R2 = 33ohm

When I simulate them in Spice, it seems the f3 might have shifted down a bit.

		Wayne, crossover and L-pad confusion By: Bill Epstein on Sun, 24 February 2008 14:48
		Top octave augmentation for compression horn tweeters By: Wayne Parham on Sun, 24 February 2008 16:54
		Re: OK, I'll quit re-inventing the wheel By: Bill Epstein on Sun, 24 February 2008 17:18
		Never! By: Wayne Parham on Sun, 24 February 2008 18:05
		Re: Pi Align strikes again! By: Bill Epstein on Tue, 26 February 2008 04:58
		Re: Upon further review By: Bill Epstein on Tue, 26 February 2008 12:10
		Re: Upon further review By: Wayne Parham on Wed, 27 February 2008 11:55
		What about 16ohm drivers By: Kim Schultz on Tue, 26 February 2008 14:18
		Correction By: Kim Schultz on Wed, 27 February 2008 03:40
		Now with measurements. By: Kim Schultz on Wed, 27 February 2008 07:04
		Re: Now with measurements. By: Wayne Parham on Wed, 27 February 2008 12:48
		Spice rules ;-) By: Kim Schultz on Wed, 27 February 2008 14:03
		Re: Spice rules ;-) By: Wayne Parham on Wed, 27 February 2008 14:22
		Re: Spice rules ;-) By: Kim Schultz on Wed, 27 February 2008 15:07
		Re: Spice rules ;-) By: Wayne Parham on Wed, 27 February 2008 18:49

Previous Topic:	Mounting Eminence Driver
Next Topic:	midbass horn

Goto Forum:

] [

]

Current Time: Fri Nov 22 21:13:56 CST 2024