Easy to add Post-assembly Bracing [message #51331 is a reply to message #51327] |
Thu, 09 August 2007 11:04 ![Go to previous message Go to previous message](/forum/theme/AudioRoundTable/images/up.png) ![Go to next message Go to previous message](/forum/theme/AudioRoundTable/images/down.png) |
Skip Pack
Messages: 51 Registered: May 2009 Location: Hollister, California
|
Baron |
|
|
I've used 1" 'dowels' several times -- available from Home Depot. Cut them to length, see if you can straighten them into position, if not sand the ends slightly and try again. Once you have a fit, take them out, smear glue on both sides and put them back. Once you see/feel what's vibrating, you get a pretty good idea about where to put them.Skip
|
|
|