Home » Sponsored » Pi Speakers » Pi Studio One Tower
A Question About the Alpha 8 [message #50503 is a reply to message #50494] Wed, 10 January 2007 06:55 Go to previous messageGo to previous message
FredT is currently offline  FredT
Messages: 704
Registered: May 2009
Illuminati (1st Degree)
I'm wondering how near the TS parameters for this driver are to the advertised specs, which appear to have been changed within the past couple of years. Here's a comparison of the specs on the Parts Express 2005 catalog versus the 2006 catalog (I understand the change was actually made before 2005 but wasn't reflected in that catalog):

Parameter - Old/New
LE - .65mH/.44mH
Fs - 76/73
SPL - 97/94
Vas - 0.5/0.6
Qms - 4.5/4.6
Qes - .6/.68
Qts - .53/.59

I'm not suggesting that WinISD always yields the optimum solution, but when I enter these different parameters, for the old parameters the software suggests a ported 1.23 cu ft box tuned to 57.5hz. For the new parameters I get a 2.1 cu ft box tuned to 49.5 hz. The F3 for the old alignment is 51hz; for the new one its 44hz. Quite a difference.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Pi 4 plans request
Next Topic: 3pi sub plans
Goto Forum:
  


Current Time: Wed Nov 27 08:53:05 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest