Home » Sponsored » Pi Speakers » piezos (to DB)
Re: (My) Dual section piezo horn [message #49541 is a reply to message #49539] Mon, 29 May 2006 09:01 Go to previous messageGo to previous message
Bill Thornton is currently offline  Bill Thornton
Messages: 23
Registered: May 2009
Chancellor

Ive just taken the x-over off the back of the "MLS" to check and what I ended up with was 0.47uf (green oblong -like a candy!) in series and 22 ohm 5% wire wound in parallel to neg rail. There are also some inductors in series with the Wharfedales and a 1 uf (green rectangle, not electrolytic)in parallel to neg rail. this is the area that needs attention I think.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: push-pull - isobarik bass
Next Topic: My new two Pi Studios
Goto Forum:
  


Current Time: Fri Nov 29 22:57:14 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest