AudioRoundTable.com: Pi Speakers » Need some speaker advice Wayne (and others)

Home » Sponsored » Pi Speakers » Need some speaker advice Wayne (and others)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Second this... [message #49347 is a reply to message #49346]

Tue, 18 April 2006 17:59

Matts
Messages: 359
Registered: May 2009

Grand Master

I'll think you'll enjoy the difference. I was wondering if you had them. After you get them in and broken in, you might try the speaks w/out the sub and see what you think... Not just lower bass, but much better defined. The 55hz is probably close to where the original iron goes comfortably.

Report message to a moderator

[Message index]

		Need some speaker advice Wayne (and others) By: Old Brown Eyes on Mon, 17 April 2006 13:37
		Re: Need some speaker advice Wayne (and others) By: Wayne Parham on Mon, 17 April 2006 14:05
		Re: Need some speaker advice Wayne (and others) By: Pfenning on Tue, 18 April 2006 11:28
		Re: Second this... By: Matts on Tue, 18 April 2006 12:21
		Re: Second this... By: Pfenning on Tue, 18 April 2006 17:08
		Re: Second this... By: Matts on Tue, 18 April 2006 17:59
		Thanks gents, how hard are the cabinets to make? By: Old Brown Eyes on Thu, 20 April 2006 06:29
		Re: Thanks gents, how hard are the cabinets to make? By: Matts on Thu, 20 April 2006 07:19
		Re: Thanks gents, how hard are the cabinets to make? By: Wayne Parham on Thu, 20 April 2006 10:10
		Re: Thanks gents, how hard are the cabinets to make? By: Old Brown Eyes on Thu, 20 April 2006 10:47
		Re: Thanks gents, how hard are the cabinets to make? By: Wayne Parham on Thu, 20 April 2006 22:39
		Re: Thanks gents, how hard are the cabinets to make? By: Spinjack on Fri, 21 April 2006 08:36
		Re: Thanks gents, how hard are the cabinets to make? By: Wayne Parham on Sun, 23 April 2006 22:10
		Re: Thanks gents, how hard are the cabinets to make? By: Russellc on Tue, 25 April 2006 14:31
		Re: Thanks gents, how hard are the cabinets to make? By: Wayne Parham on Tue, 25 April 2006 14:50

Previous Topic:	Compensation circuit for 16-Ohm JBL 2426/2370
Next Topic:	Attenuation for Theatre-3

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Mar 02 16:48:03 CST 2025