Home » Sponsored » Pi Speakers » piezos
Re: KSN 1038 [message #48932 is a reply to message #48931] Mon, 20 February 2006 17:35 Go to previous messageGo to previous message
Bill Thornton is currently offline  Bill Thornton
Messages: 23
Registered: May 2009
Chancellor
Yes I had visited this site before and I had already determined to sling 6 or so ohms across the piezo and cross them conventionally at either 3K or 4k actually adding about 0.68Mh to the 5" to stop things getting to bright in the upper mids and then padding down the tweeter
till it all smoothed out (if at all!)But now it looks like these clones
may not be anything like the originals and I could be on a wild goose chase. Still as I say, apart from being a bit " shouty " in the upper mids they dont sound that bad! but then again I am the wrong side of 55
and they old tin ear is beginning to take its toll.Incidently ,I emailed
this CPC outfit and asked them for a response graph & surprise ,surprise the girl there says she will fax me one. If it looks anything like a
KSN1038 Ill report back!

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: Seven pi-18 photos?
Next Topic: Is this flattery?
Goto Forum:
  


Current Time: Mon Nov 25 21:02:14 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest