Home » Sponsored » Pi Speakers » piezos
Re: piezos [message #48924 is a reply to message #48922] Mon, 20 February 2006 04:07 Go to previous messageGo to previous message
Bill Thornton is currently offline  Bill Thornton
Messages: 23
Registered: May 2009
Chancellor

The 5" units were originally fitted in wharfedale diamond speakers and are good for 50hz up to about 8Khz But I also have 2 10" speakers mounted under the stairs (were tight for space in this cottage!) that can act as a sub for the lower registers.If you wish to get the full story visit the DIY audio website and read the " My Little speakers " thread. P.s. the piezos arrived in the post and are the same as originally supplied (clones) but in fairness to Comet they were supplied to them as Motorola Ksn1038 by a firm called CPC (they are in their original packaging )So CAVEAT EMPTOR everyone!Its back to the drawing board. The speakers sound reasonable with the clones in ,I may just raise the x/over point and pad them down and try the doping & damping tricks.



 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: Seven pi-18 photos?
Next Topic: Is this flattery?
Goto Forum:
  


Current Time: Fri Nov 22 11:43:19 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest