AudioRoundTable.com: Pi Speakers » Request for wooden HF horn plans

Home » Sponsored » Pi Speakers » Request for wooden HF horn plans

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: What High Frequency Horns? Where? [message #48159 is a reply to message #48147]

Fri, 11 November 2005 19:40

Bill Martinelli
Messages: 677
Registered: May 2009

Illuminati (1st Degree)

I dont remember plans like that. You did some work in horn response that gave the best angle for the conical throat since I wanted to make a seperate aluminum throat piece. Not only dont I remember plans for any type of horn like that. The horns I've been making have curves sides. not flat. and the top and bottom are not curves but a straight +10 degree in proportion to the flair rate. Good luck with your new horns. The cnc stuff sounds cool.

Report message to a moderator

[Message index]

		Request for wooden HF horn plans By: DrRick on Fri, 11 November 2005 02:45
		Re: What High Frequency Horns? Where? By: Bill Epstein on Fri, 11 November 2005 03:18
		Re: What High Frequency Horns? Where? By: Wayne Parham on Fri, 11 November 2005 07:09
		Re: What High Frequency Horns? Where? By: Bill Martinelli on Fri, 11 November 2005 19:40
		Re: What High Frequency Horns? Where? By: Wayne Parham on Sat, 12 November 2005 00:04
		Re: What High Frequency Horns? Where? By: Bill Epstein on Sun, 13 November 2005 12:05
		Re: What High Frequency Horns? Where? By: Wayne Parham on Sun, 13 November 2005 13:36

Previous Topic:	MA Audiophile Get Together
Next Topic:	Request for 2 pi tower speaker plans

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 15:16:09 CST 2024