AudioRoundTable.com: Pi Speakers » Heat Exchanger Design mods

Home » Sponsored » Pi Speakers » Heat Exchanger Design mods

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Heat Exchanger Design mods [message #47670]

Mon, 05 September 2005 19:14

Monomer
Messages: 18
Registered: May 2009

Chancellor

I just started making mine, and they wont be used with a plate. They will be in free-air (the speaker's magnet structure sticks out into the horn, not the chamber: Tuba30slim)

Chamfer the end that go's into the speaker (ID) This looks like it might help with turblence and whatnot. Same go's for the holes on the toppeice.

I left a bit (I made it 2.100/inch long on my mag12ho) of space on the inside, you dont want it to rub the inside, and you want to allow air to easiley enter it.

I'm learning howto use SolidWorks right now, and this looks like it might be a proper starting project to draw out. I'll try to get a cad drawing of it up when mine are finished and working.

PS: sorry for any mispelling above.

Report message to a moderator

[Message index]

		Heat Exchanger Design mods By: Monomer on Mon, 05 September 2005 19:14
		Re: Heat Exchanger Design mods By: Wayne Parham on Mon, 05 September 2005 22:20
		Re: Heat Exchanger Design mods By: Monomer on Tue, 06 September 2005 12:48
		Re: Heat Exchanger Design mods By: Wayne Parham on Tue, 06 September 2005 16:56
		Re: Heat Exchanger Design mods By: Matts on Tue, 06 September 2005 20:19
		Re: Heat Exchanger Design mods By: Monomer on Sun, 18 September 2005 12:52
		Heat Exchanger / Cooling Plug Information By: Wayne Parham on Mon, 19 September 2005 06:21

Previous Topic:	New photos of the 12π basshorn sub build
Next Topic:	Upgrades

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Dec 02 17:26:42 CST 2024