Home » Sponsored » Pi Speakers » Audiophile Series seven π
JBL & amp design [message #47639 is a reply to message #47623] Thu, 01 September 2005 13:25 Go to previous messageGo to previous message
beto1 is currently offline  beto1
Messages: 36
Registered: May 2009
Baron
Hi Wayne,
I have read lots of forum post about the SET low power and JBL 2226 driver and now I know that this will work very well with some SET's amps but depends on the amp design (damping factor, impedance, etc). So, the question is about the Audio Note Kit One 300B SET(running at 420 volts with 75mA current), directly heated, no negative feedback, class A, works with the JBL's. I supose that The KIt One is similar in the low output impedance with the Kit 2, but with a little less output watts. On the paper this will design will give 9 or10 watt, but I prefer to asume only 7 or 8 watts to be conservative.
I don't know if I need to provide more specifications for the kit one, like the exact damping factor, but surely I can get this info with Brian, the AN kit seller.
Thank you again.
Alberto

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Ping: ColinHester
Next Topic: Anyone have comments on the Stage four Pi or pictures of finished Pi's
Goto Forum:
  


Current Time: Sat Aug 03 01:22:28 CDT 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest