AudioRoundTable.com: Pi Speakers » Mid-horn "Chamber"

Home » Sponsored » Pi Speakers » Mid-horn "Chamber"

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Mid-horn "Chamber" [message #47559 is a reply to message #47556]

Thu, 25 August 2005 12:37

Russellc
Messages: 397
Registered: May 2009

Illuminati (1st Degree)

As I recall when I first asked a similar question about the mid horn
was that it just had to be at least 1/2 cubic foot. ( I dont think it is possible for you to make it any smaller) apparently it isnt that critical about size. More to prevent a back wave off the rear of the driver then reflecting out of the corner and messing with the sound off the front of the horn. Is that about right wayne? Hope this helps.

Russellc

Report message to a moderator

[Message index]

		Mid-horn "Chamber" By: Spinjack on Thu, 25 August 2005 12:13
		Re: Mid-horn "Chamber" By: Wayne Parham on Thu, 25 August 2005 12:26
		Re: Mid-horn "Chamber" By: Spinjack on Thu, 25 August 2005 13:36
		Re: Mid-horn "Chamber" By: Wayne Parham on Thu, 25 August 2005 13:48
		Re: Mid-horn "Chamber" By: Spinjack on Thu, 25 August 2005 15:17
		Re: Mid-horn "Chamber" By: Wayne Parham on Thu, 25 August 2005 15:55
		Re: Mid-horn "Chamber" By: Spinjack on Mon, 29 August 2005 11:28
		Re: Mid-horn "Chamber" By: Spinjack on Thu, 25 August 2005 13:47
		Re: Mid-horn "Chamber" By: Wayne Parham on Thu, 25 August 2005 13:49
		Re: Mid-horn "Chamber" By: Spinjack on Thu, 25 August 2005 15:11
		Re: Mid-horn "Chamber" By: Wayne Parham on Thu, 25 August 2005 15:32
		Re: Mid-horn "Chamber" By: Spinjack on Thu, 25 August 2005 15:40
		Re: Mid-horn "Chamber" By: Russellc on Thu, 25 August 2005 17:52
		Re: Mid-horn "Chamber" By: Wayne Parham on Thu, 25 August 2005 22:22
		Re: Mid-horn "Chamber" By: Russellc on Thu, 25 August 2005 12:37

Previous Topic:	66x24x36
Next Topic:	75 watts

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 01:48:39 CST 2024