Home » Sponsored » Pi Speakers » Thoughts on the Fostex FW305??
Re: Crossover Electronics 101 [message #46550 is a reply to message #46544] Wed, 23 March 2005 18:32 Go to previous messageGo to previous message
josephjcole is currently offline  josephjcole
Messages: 4
Registered: May 2009
Esquire
Layne/Onespeed was kind enough to point me to this thread, as we have been discussing fostex drivers crossed over to high effeciency woofers. I've been working on a 4" fostex driver crossed over to an Eminence Delta 12lf, and I've been quite pleased with the results so far. I am curious about your suggestion to put a resistor across the fostex. Is this to compensate for the peak in impedence at driver fs, or the box's resonant frequency? If so would crossing over 2 octaves above both of these negate the need for a resistor in parallel with the fostex? Obviously I am still learning. Thanks in advance.
Joe

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Substitutions for 22uF cap in Theater 4 crossover
Next Topic: New power amp IC's as AudioExpress
Goto Forum:
  


Current Time: Mon Nov 18 15:22:04 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest