Home » Sponsored » Pi Speakers » How Much Power?
Re: How Much Power? [message #43440 is a reply to message #43428] Mon, 22 December 2003 09:55 Go to previous messageGo to previous message
DRC is currently offline  DRC
Messages: 169
Registered: May 2009
Master
Well, I drove a pair of pair of Audiophile 4's at a New England Bottlehead meet (two meets ago) with a 6v6 pushpull amp (10 watts?) on the TAD 1602's following an active xo, and a a pair of 300B amps (9w/ch) driving the passive xo JBL mids and TAD 2001 tweets.

The Bots were leaning toward arena rock on vinyl at that point, and in a good sized living room/kitchen area it was damned convincing. (The JBL 2123 mid was a bit prominent, and Bill M. found the bass/cab a bit "thrummy", but it ROCKED just fine.)

 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Other horn flares
Next Topic: Conical horn to the rescue!
Goto Forum:
  


Current Time: Thu Nov 28 19:44:02 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest