AudioRoundTable.com: Pi Speakers » How to choose the correct Horn??

Home » Sponsored » Pi Speakers » How to choose the correct Horn??

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Set your goals, model a design and build it [message #42921 is a reply to message #42915]

Thu, 06 November 2003 06:51

Jeremy Bridge
Messages: 4
Registered: May 2009

Esquire

You commented that the length of the sides and thier angle control the dispersion in a low-mid horn. But do you know how I would go about making that 60x40 to match the high horn?

I have used horn resp, before but I am just not confident of my results. I have a very hard time getting any response abouve 1000hz out of any mid horn I model in it. Perhaps I should bite the bullet though and take a shot at building one.

You commented you like Constant Directivity Radial horns, one of the horns on the top of my list is just that. Do you happen to know if Eminence's TI2000 is a nice sounding, good quality horn?

Report message to a moderator

[Message index]

		How to choose the correct Horn?? By: Jeremy Bridge on Wed, 05 November 2003 19:39
		Set your goals, model a design and build it By: Wayne Parham on Wed, 05 November 2003 22:29
		Re: Set your goals, model a design and build it By: Jeremy Bridge on Thu, 06 November 2003 06:51
		Re: Set your goals, model a design and build it By: Wayne Parham on Thu, 06 November 2003 07:17
		Re: Set your goals, model a design and build it By: Jeremy Bridge on Thu, 06 November 2003 11:38
		Re: Set your goals, model a design and build it By: Wayne Parham on Thu, 06 November 2003 23:19

Previous Topic:	Journal of a First-time Builder - Pt 1: Assembly
Next Topic:	Anyone good with Speaker Workshop???

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 24 02:25:03 CST 2024