AudioRoundTable.com: Pi Speakers » Theater 4 Pi Driver Screws

Home » Sponsored » Pi Speakers » Theater 4 Pi Driver Screws

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Theater 4 Pi Driver Screws [message #41926 is a reply to message #41925]

Tue, 15 July 2003 04:51

Larry Acklin
Messages: 54
Registered: May 2009

Baron

I use 1/4 inch hex head bolts with t-nuts. I mix some jb-weld and use it to seat the t-nut, and to "seal" around the outside of the t-nut flange. I draw the t-nut in using a bolt and washer (no hammering). This works well for me on the PA cabinets. I mount the driver with the 1/4 inch bolts and a washer under the head.

Larry Acklin

Report message to a moderator

[Message index]

		Theater 4 Pi Driver Screws By: elektratig on Tue, 15 July 2003 03:20
		Re: Theater 4 Pi Driver Screws By: Larry Acklin on Tue, 15 July 2003 04:51
		Re: Theater 4 Pi Driver Screws By: Matts on Tue, 15 July 2003 05:06
		Re: Theater 4 Pi Driver Screws By: Wayne Parham on Tue, 15 July 2003 09:27

Previous Topic:	A little surprise for ya Wayne...
Next Topic:	BAH stupid JBL recones!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Aug 13 16:10:18 CDT 2024