AudioRoundTable.com: Pi Speakers » Help on making driver measurements, please?

Home » Sponsored » Pi Speakers » Help on making driver measurements, please?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Help on measurements, Thanks Bill [message #41791 is a reply to message #41790]

Wed, 02 July 2003 17:50

Bill Martinelli
Messages: 677
Registered: May 2009

Illuminati (1st Degree)

I have not put together one of the test jigs so if this is an important thing to have that would explain a lot. From reading through the directions It seemed that you could use the software with out a test jig.

I try to follow the directions to calibrate the software and after connecting a few resisters to the in and out of the sound card as described. It does not measure a correct value of a known resister after calibration.

thats about the jist of the problem.

Bill

Report message to a moderator

[Message index]

		Help on making driver measurements, please? By: wunhuanglo on Sun, 29 June 2003 16:03
		Re: Help on making driver measurements, please? By: Bill Martinelli on Sun, 29 June 2003 19:02
		Re: Help on measurements, Thanks Bill By: wunhuanglo on Mon, 30 June 2003 15:40
		Re: Help on measurements, Thanks Bill By: Bill Martinelli on Tue, 01 July 2003 05:31
		Re: Woofer Tester By: AstroSonic on Tue, 01 July 2003 19:05
		Re: Help on measurements, Thanks Bill By: JS on Wed, 02 July 2003 16:35
		Re: Help on measurements, Thanks Bill By: Bill Martinelli on Wed, 02 July 2003 17:50
		Re: Help on measurements, Thanks Bill By: ToFo on Wed, 02 July 2003 19:12
		Re: Help on measurements, Thanks Bill By: JS on Thu, 03 July 2003 05:40

Previous Topic:	TAD-JBL-Pi 3-way update
Next Topic:	Holism and Reductionism - Fourier Series

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Dec 12 12:52:30 CST 2024