AudioRoundTable.com: Pi Speakers » triamp Q for Wayne

Home » Sponsored » Pi Speakers » triamp Q for Wayne

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: 902 crossover point [message #41641 is a reply to message #41638]

Mon, 16 June 2003 19:09

AstroSonic
Messages: 58
Registered: May 2009

Baron

I suspect that the recommendation of 1200 Hz as a crossover frequency for the 902/511 and the 902/811 combinations had more to do with power handling (and abuse/misapplication in the field) than with amplitude-frequency linearity. The literature for the Altec small format drivers pretty clearly suggests that they are meant to be used from 500 Hz up (with the 511 horn) and 800 Hz up (with the 811 horn) in smaller settings where they could provide the same bandwidth as the large format drivers and their lower power handling capacity was adequate. Perhaps one of the Altec pros could weigh in on this.

AstroSonic

Report message to a moderator

[Message index]

		triamp Q for Wayne By: Sam P. on Mon, 16 June 2003 06:41
		511's in a three-way By: Wayne Parham on Mon, 16 June 2003 10:37
		Re: 902 crossover point By: wunhuanglo on Mon, 16 June 2003 16:51
		Re: 902 crossover point By: Wayne Parham on Mon, 16 June 2003 18:04
		Re: 902 crossover point By: AstroSonic on Mon, 16 June 2003 19:09
		Re: 902 crossover point By: Tom Brennan on Mon, 16 June 2003 20:58
		Re: Proper horn for 902/500Hz Xover By: AstroSonic on Tue, 17 June 2003 04:35
		Re: Proper horn for 902/500Hz Xover By: Tom Brennan on Tue, 17 June 2003 14:36
		Matching directivity By: ToFo on Tue, 17 June 2003 08:31

Previous Topic:	Concern frequency response 16Khz?
Next Topic:	wedge for corner horns

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jul 31 09:16:34 CDT 2024