AudioRoundTable.com: Pi Speakers » Could I squeeze a 2pi into this cabinet?

Home » Sponsored » Pi Speakers » Could I squeeze a 2pi into this cabinet?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Skill saw tricks [message #41321 is a reply to message #41300]

Tue, 13 May 2003 08:16

WhoWasILastWeek?
Messages: 1
Registered: May 2009

Esquire

You can buy or better yet make your own cutting jig for a skill saw. It will make ruler straight cuts and be as Accurate and Square as you take time to measure and clamp it (elli may) in place. Since the saw runs on top of the guide there is no tear out on the top side under the guide either. You can make very nice cuts with an inexpensive skill saw. A good blade is more important than the saw i'm afraid.

Patty Hurst

Report message to a moderator

[Message index]

		Could I squeeze a 2pi into this cabinet? By: RJeff on Sun, 11 May 2003 11:25
		Re: Could I squeeze a 2pi into this cabinet? By: Wayne Parham on Sun, 11 May 2003 12:10
		Internal volume By: RJeff on Sun, 11 May 2003 13:10
		one π By: Wayne Parham on Sun, 11 May 2003 13:39
		Re: Could I squeeze a 2pi into this cabinet? By: BillEpstein on Sun, 11 May 2003 17:49
		Not MY home depot By: RJeff on Mon, 12 May 2003 06:05
		Re: My Home Depot has the same sign.... By: Matts on Mon, 12 May 2003 10:29
		Re: My Home Depot has the same sign.... By: Wayne Parham on Mon, 12 May 2003 13:07
		Re: where there's a will, there's a relative By: Juan Epstein on Tue, 13 May 2003 05:03
		What's Wrong With Ryobi By: elektratig on Tue, 13 May 2003 14:43
		Re: Skill saw tricks By: WhoWasILastWeek? on Tue, 13 May 2003 08:16
		Sawboard By: elektratig on Tue, 13 May 2003 14:56
		Re: Sawboard By: JuanEpstein on Wed, 14 May 2003 08:02

Previous Topic:	The Ps (Sam and Wayne) made me do it
Next Topic:	dml-1152mc

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Aug 20 05:04:25 CDT 2025