AudioRoundTable.com: Pi Speakers » HF Horn-Woofer phase at crossover

Home » Sponsored » Pi Speakers » HF Horn-Woofer phase at crossover

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: HF Horn-Woofer phase at crossover [message #41182 is a reply to message #41180]

Thu, 01 May 2003 10:26

ToFo
Messages: 219
Registered: May 2009

Master

I think Valencia was a home finished model. I have seen some drawings and if memory serves the woofer was a bit recessed in the box. That might have been about right for 800Hz. It would depend on the slope and other issues in the crossover/wiring scheme, and perhaps they didn't even address it. too many variables to consider on appearance alone. As for the folks who build trolleys to fly the horn out front, this is a good idea to get the phase to gel at the crossover frequency. If you have too much overlap though, you will be adjusting for one range while cancelling another. The crossover document has some nice explanations of phase relationships at crossover, check it out. Also I think Sam P. has his altec horns like this.

Thomas

crossover doc

Report message to a moderator

[Message index]

		HF Horn-Woofer phase at crossover By: AstroSonic on Thu, 01 May 2003 08:07
		Re: HF Horn-Woofer phase at crossover By: Sam P. on Thu, 01 May 2003 10:21
		Re: Thanks! By: AstroSonic on Thu, 01 May 2003 15:22
		Re:ringing By: Sam P. on Thu, 01 May 2003 17:00
		Jet-Hot By: Wayne Parham on Thu, 01 May 2003 20:33
		Re:Radical DeStressing 511B's By: AstroSonic on Fri, 02 May 2003 04:27
		Re:go for it! By: Sam P. on Fri, 02 May 2003 05:28
		Re: HF Horn-Woofer phase at crossover By: ToFo on Thu, 01 May 2003 10:26
		Re: HF Horn-Woofer phase at crossover By: Wayne Parham on Thu, 01 May 2003 11:32

Previous Topic:	"B" sides
Next Topic:	Theater 4 Pi + .5mh in woofer circuit... Wayne ?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Jul 31 13:24:01 CDT 2024