AudioRoundTable.com: Pi Speakers » interconnect question

Home » Sponsored » Pi Speakers » interconnect question

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

interconnect answer [message #40178 is a reply to message #40168]

Thu, 06 February 2003 12:56

Wayne Parham
Messages: 18786
Registered: January 2001

Illuminati (33rd Degree)

The difference between balanced and unbalanced signal pairs is that balanced lines are "push-pull" and unbalanced lines have a ground that the signal is referenced to. All other things being equal, a balanced pair is less sensitive to noise.

The best things for noise reduction are:

Being shielded
Using balanced pairs, and
Being low impedance

Will you be in Lima?

Report message to a moderator

[Message index]

		interconnect question By: replay on Thu, 06 February 2003 05:41
		Canare, Cool! By: ToFo on Thu, 06 February 2003 08:36
		bryston uses.... By: replay on Thu, 06 February 2003 10:52
		Thanks, I think i'll try that! By: ToFo on Thu, 06 February 2003 14:33
		well, found something cool! By: ToFo on Thu, 06 February 2003 09:01
		interconnect answer By: Wayne Parham on Thu, 06 February 2003 12:56
		i'll be there! By: replay on Thu, 06 February 2003 16:53
		Flying By: mikebake on Thu, 06 February 2003 17:39
		Logistics By: Wayne Parham on Thu, 06 February 2003 22:03
		That is easy By: mikebake on Fri, 07 February 2003 12:38
		Re: That is easy By: Wayne Parham on Sat, 08 February 2003 13:48
		Cool By: mikebake on Sat, 08 February 2003 14:00
		Re: i'll be there! By: Wayne Parham on Thu, 06 February 2003 22:10

Previous Topic:	New DIY Pi Speaker owner and have build questions
Next Topic:	60hz-220hz peak problem

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Nov 27 04:37:36 CST 2024