AudioRoundTable.com: Pi Speakers » Tweeter 1/2" to low :(

Home » Sponsored » Pi Speakers » Tweeter 1/2" to low :(

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Odds and ends [message #40084 is a reply to message #40078]

Wed, 29 January 2003 00:14

Wayne Parham
Messages: 18787
Registered: January 2001

Illuminati (33rd Degree)

You're right - the wire with the spool should be attached to the midwoofer. Be sure that the lead positive lead of your connector panel is connected to the positive lead of your tweeter and also the positive lead of your midwoofer, through the inductor. I forget if your kits have the inductor that would be screw mounted or not - If you have a hole on the spool that would fit a small screw, us that to attach the coil to the inside back wall. If not, use automotive weatherstrip glue.

Report message to a moderator

[Message index]

		Tweeter 1/2" to low :( By: dobanion on Tue, 28 January 2003 16:30
		Re: Tweeter 1/2" to low :( By: bmar on Tue, 28 January 2003 18:18
		Re: OR...... By: BillEpstein on Tue, 28 January 2003 18:28
		Re: OR...... By: bmar on Tue, 28 January 2003 19:21
		Re: Tweeter 1/2" to low :( By: dobanion on Tue, 28 January 2003 19:32
		Odds and ends By: Wayne Parham on Wed, 29 January 2003 00:14
		Re: Tweeter 1/2" to low :( By: mollecon on Tue, 28 January 2003 23:25
		No problem By: Wayne Parham on Wed, 29 January 2003 00:09
		Re: Tweeter 1/2" to low :( By: dobanion on Wed, 29 January 2003 06:49

Previous Topic:	Theater 4pi audition
Next Topic:	Pi Theater 4s at Outdoor Wedding Reception

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 23 17:38:45 CST 2024