AudioRoundTable.com: Pi Speakers » 4Pi Pro questions for Wayne, et al

Home » Sponsored » Pi Speakers » 4Pi Pro questions for Wayne, et al

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

I'll have what ron's smoking:) [message #39791 is a reply to message #39789]

Wed, 08 January 2003 13:33

Sam P.
Messages: 307
Registered: May 2009

Grand Master

OK, time to clarify.

"since a 8 ohm 1.6khz crossover should equal a 800 hz crossover for 16 ohms (and it should), "

Not quite. Using 2nd order BW's for example, the 1.6kHz/8 ohm xover requires 8.8uF and a 1.12mH choke. An 800Hz/16 ohm xover requires 8.8uF cap, YES, BUT the choke needed is 4.5mH...

A google search for "crossover calculator" will turn up the web site for "Select Products" on-line applet. Sam

Report message to a moderator

[Message index]

		4Pi Pro questions for Wayne, et al By: BillEpstein on Tue, 07 January 2003 17:25
		Re: 4Pi Pro questions for Wayne, et al By: bmar on Tue, 07 January 2003 18:06
		Baffle mounting By: Wayne Parham on Tue, 07 January 2003 21:49
		Altec 806A are 16 ohm compression drivers By: spkrman57 on Wed, 08 January 2003 10:45
		Complex reactive/resistive loads By: Wayne Parham on Wed, 08 January 2003 11:52
		Re: Complex reactive/resistive loads By: Charlie on Wed, 08 January 2003 18:04
		Re: Complex reactive/resistive loads By: Wayne Parham on Wed, 08 January 2003 19:07
		different strokes(long) By: Sam P. on Thu, 09 January 2003 07:19
		I'll have what ron's smoking:) By: Sam P. on Wed, 08 January 2003 13:33

Previous Topic:	4 pi & 7 pi
Next Topic:	Any known issues with Eminence APT super-tweeters?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Jul 14 00:56:39 CDT 2024