Home » Sponsored » Pi Speakers » Driver Escalation
Re: Driver Escalation [message #38818 is a reply to message #38800] Fri, 25 October 2002 07:01 Go to previous messageGo to previous message
DRC is currently offline  DRC
Messages: 169
Registered: May 2009
Master
If I were to go three way (sssomebody ssstop me!!!!) with the 2131's, would the same cabinet still work for both the 1602's and the 2131's, or should they be wholly or partially (perforated shelf going sideways between them?) separated or . . . ?

Given the operating range of the three drivers, I'm thinking of crossing the 1602 to the 2123 gently at 200hz, then more steeply to the tweeter (PSD2002 to start) at 1600. That would give the JBL 3 critical octaves to cover.

(Still pinata-bashing, free-wheeling without much of a clue!)

Thanks!
Keep your ears and your mind open.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: here's a party few are sure to attend..........
Next Topic: Wayne, how cool it is! (a 1 Pi story)
Goto Forum:
  


Current Time: Sat Nov 30 14:27:23 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest