Home » Sponsored » Pi Speakers » A Question About Reflex Ports
Re: A Question About Reflex Ports [message #38723 is a reply to message #38706] Fri, 18 October 2002 18:33 Go to previous message
mollecon is currently offline  mollecon
Messages: 203
Registered: May 2009
Master
In his book "High Performance Loudspeakers" Martin Colloms have a few things to say on the subject. He claims that to make sure to avoid windy noises the port diameter should be 7 cm. (2.8") or more. He also says that the diameter to length ratio should be no more than 1:2.

While the above is easily achieved in larger boxes tuned at frequencies > 40Hz, the opposite is the case when it comes to the now fashionable compact subwoofers with internal volumes well below 40 liters ( < 1½ cu.ft. ), & low tuning frequencies. In those cases a passive radiator is often used or alternatively the ends of a small diameter port are 'radiused' to avoid wind noises.

 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Over the Falls!
Next Topic: updated pics on site (crossovers too)
Goto Forum:
  


Current Time: Wed Nov 27 19:54:23 CST 2024

Sponsoring Organizations

DIY Audio Projects
DIY Audio Projects
OddWatt Audio
OddWatt Audio
Pi Speakers
Pi Speakers
Prosound Shootout
Prosound Shootout
Miller Audio
Miller Audio
Tubes For Amps
TubesForAmps.com

Lone Star Audiofest