AudioRoundTable.com: Pi Speakers » Coils on one π's and two π's

Home » Sponsored » Pi Speakers » Coils on one π's and two π's

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Coils on one π's and two π's [message #38400 is a reply to message #38397]

Sun, 22 September 2002 20:28

Wayne Parham
Messages: 18789
Registered: January 2001

Illuminati (33rd Degree)

I had considered attaching the coils to the connector panel with epoxy, or perhaps tied near them with cables ties similar to the way you've described. But I think one of the best ways would be to use a strain relief wrapped around the coil and fastened to a cabinet panel by screw. You can find strain reliefs that are made to hold a wire tie, and that would be perfect for your application.

Report message to a moderator

[Message index]

		Coils on one π's and two π's By: Wayne Parham on Sun, 22 September 2002 14:30
		Re: Coils on one π's and two π's By: Matts on Sun, 22 September 2002 15:42
		Re: Coils on one π's and two π's By: Wayne Parham on Sun, 22 September 2002 20:28
		Of course it's not a crossover, it's....... By: BillEpstein on Sun, 22 September 2002 17:05
		Re: Of course it's not a crossover, it's....... By: Wayne Parham on Sun, 22 September 2002 20:33
		Re: Coils on one π's and two π's By: bqc on Sun, 22 September 2002 17:56
		20 ohm resistors across the amp outputs By: Wayne Parham on Sun, 22 September 2002 21:39

Previous Topic:	oops!
Next Topic:	1pi port question

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 20:38:36 CST 2024