AudioRoundTable.com: Pi Speakers » physics of port tuning

Home » Sponsored » Pi Speakers » physics of port tuning

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: re: [message #38147 is a reply to message #38144]

Tue, 03 September 2002 08:52

Adam
Messages: 419
Registered: May 2009

Illuminati (1st Degree)

There is an "end correction" factor involved with multiple ports. I'm not completely aware of the physics behind it, but I believe it is because there is increased air drag on the inner walls of the port when you use two smaller ports verses a single large port. Thus the length has to be increased a small amount to compensate. Usually no more then a couple of inches.

Is this what you're talking about?

Adam

Report message to a moderator

[Message index]

		physics of port tuning By: dbeardsl on Mon, 02 September 2002 00:45
		not sure what you mean... By: Sam P. on Mon, 02 September 2002 08:51
		re: By: dbeardsl on Tue, 03 September 2002 01:01
		port calcs By: vladimir4 on Tue, 03 September 2002 02:02
		Re: re: By: Adam on Tue, 03 September 2002 08:52
		multiple ports By: dbeardsl on Tue, 03 September 2002 18:40
		Exact value By: vladimir4 on Wed, 04 September 2002 01:00
		Re: physics of port tuning By: Jostein on Tue, 03 September 2002 05:28

Previous Topic:	Is this why JBL 2245 was discontinued ?
Next Topic:	frosting on the pi

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 19:12:08 CST 2024