AudioRoundTable.com: Pi Speakers » Crossover question(s)

Home » Sponsored » Pi Speakers » Crossover question(s)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

L2 should be 0.7mH w/ the 2226H's [message #37885 is a reply to message #37884]

Mon, 19 August 2002 10:35

Sam P.
Messages: 307
Registered: May 2009

Grand Master

but I would not go to the expense or trouble of increasing the wattage ratings for R1/R2. Mine are "derated" down to 24 watts for R1, and 36 watts for R2. This allowed me to use a pair of non-inductive Mills resistors for R1, and a trio of them for R2. Wayne's 40 watt specification has an adequate safety margin built in already, going larger will not be needed. Sam

Report message to a moderator

[Message index]

		Crossover question(s) By: LuxmanLover on Mon, 19 August 2002 10:17
		Re: Crossover question(s)Part 2 By: LuxmanLover on Mon, 19 August 2002 10:22
		L2 should be 0.7mH w/ the 2226H's By: Sam P. on Mon, 19 August 2002 10:35
		Re: L2 should be 0.7mH w/ the 2226H's By: bmar on Mon, 19 August 2002 18:01

Previous Topic:	Two Pi's Up and Running!!
Next Topic:	more on (or moron on ) crossovers

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Nov 27 15:17:29 CST 2024