AudioRoundTable.com: Pi Speakers » altec gear in a pi box??

Home » Sponsored » Pi Speakers » altec gear in a pi box??

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Tommy, I based my remarks upon Altec's [message #37522 is a reply to message #37518]

Fri, 26 July 2002 08:32

Sam P.
Messages: 307
Registered: May 2009

Grand Master

published data, where freq. response graphs showed they were flat down to 1kHz., then start to roll off. I'm surprised as many complaints have been posted regarding poor HF performance with 800 series Altecs that you could recommend them. "Uncomped" 902's w/ 34647 'phrams run out to 14kHz or better. As I stated, his linearity will be better, and distortion lower, if he crosses at 800Hz. And 902's have superior HF extension.

I was trying to HELP HIM AVOID being sucked into the "vintage is always better trap" where he will buy a beat set of mismatched drivers, send them off to be remagged, have them still suck, buy new 'phrams, and lose interest eventually. Or obtain his 825/828 boxes, then find out he needs a friggin' subwoofer too...Sam

Report message to a moderator

[Message index]

		altec gear in a pi box?? By: EZ_Angus on Thu, 25 July 2002 19:08
		π speakers with Altec parts By: Wayne Parham on Thu, 25 July 2002 19:45
		the 500Hz. xover "myth" By: Sam P. on Fri, 26 July 2002 05:19
		Re: the 500Hz. xover "myth" By: Tom Brennan on Fri, 26 July 2002 07:11
		Tommy, I based my remarks upon Altec's By: Sam P. on Fri, 26 July 2002 08:32
		Re: altec gear in a pi box?? By: EZ_Angus on Fri, 26 July 2002 08:01
		Re: altec gear in a pi box?? By: Wayne Parham on Fri, 26 July 2002 12:52
		Re: altec gear in a pi box?? 825 cabinet By: Tom Brennan on Fri, 26 July 2002 20:22
		Re: altec gear in a pi box?? By: EZ_Angus on Fri, 26 July 2002 15:58
		Re: altec gear in a pi box?? By: Wayne Parham on Sat, 27 July 2002 00:57

Previous Topic:	Anyone need a JBL 4648A-8 or some 2226J woofers, contact me off list
Next Topic:	replacing mid range speaker

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 30 10:58:45 CST 2024