AudioRoundTable.com: Pi Speakers » Just bought pre-cut MDF for my One Pi speakers!

Home » Sponsored » Pi Speakers » Just bought pre-cut MDF for my One Pi speakers!

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Building the cabinets [message #37380 is a reply to message #37379]

Thu, 18 July 2002 15:00

BillEpstein
Messages: 886
Registered: May 2009

Illuminati (2nd Degree)

Only reason to use screws is in place of clamps. I like to use some screws even with clamps because pieces butted together tend to move when you tighten the clamps. I've also put small brads into one panel and clipped them off so they are just 1/2" proud, then they act as "spurs" to hold the adjacent panel in place.
Remember to drill the hole in the top panel larger than the screw so the under panel pulls tight.

Report message to a moderator

[Message index]

		Just bought pre-cut MDF for my One Pi speakers! By: Erik Johansson on Thu, 18 July 2002 11:24
		Forgot the "real" question! By: Erik Johansson on Thu, 18 July 2002 11:26
		Port stuff By: Wayne Parham on Thu, 18 July 2002 11:46
		Re: Port stuff By: Erik Johansson on Thu, 18 July 2002 11:50
		Re: Port stuff By: Wayne Parham on Thu, 18 July 2002 12:09
		Building the cabinets By: Erik Johansson on Thu, 18 July 2002 13:39
		Re: Building the cabinets By: BillEpstein on Thu, 18 July 2002 15:00

Previous Topic:	Sensitivity ratings for Delta 15 etc
Next Topic:	wall lining in two Pis

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Mar 03 17:22:38 CST 2025