AudioRoundTable.com: Pi Speakers » question about r13 vs acoustic foam for dampening

Home » Sponsored » Pi Speakers » question about r13 vs acoustic foam for dampening

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

one last question [message #36736 is a reply to message #36727]

Mon, 03 June 2002 06:04

ray99
Messages: 15
Registered: May 2009

Chancellor

Wayne, thanks for the very detailed answer. I will take your advice and use R13. I assume that once the R13 is stapled in place you don't have to been concerned about any glass fibers drifting out of the port hole and breathing them? Sorry if this question is too dumb.

By the way, I purchased your kit (thermionic 3) and I'm glad I did. Instructions are very clear. Construction is not that difficult, even for a novice. Thanks.

Report message to a moderator

[Message index]

		question about r13 vs acoustic foam for dampening By: ray99 on Sun, 02 June 2002 09:55
		My experience with acoustic insulation By: Wayne Parham on Sun, 02 June 2002 11:47
		one last question By: ray99 on Mon, 03 June 2002 06:04
		Re: one last answer By: Wayne Parham on Mon, 03 June 2002 08:39
		Re: one last answer By: Adam on Mon, 03 June 2002 16:59
		Airborne particulates By: Wayne Parham on Mon, 03 June 2002 20:51

Previous Topic:	Thanks Wayne!!!
Next Topic:	Pi center channel and sub

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Jun 29 10:52:24 CDT 2024