AudioRoundTable.com: Pi Speakers » Lathe turned horn for PSD2002

Home » Sponsored » Pi Speakers » Lathe turned horn for PSD2002

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Lathe turned horn for PSD2002 [message #36592 is a reply to message #36585]

Thu, 23 May 2002 10:13

str8aro
Messages: 12
Registered: May 2009

Chancellor

Just be careful if that's a wood lathe you're talking about. The headstock bearings might be much more robust in a metal lathe. Don't you usually use a tailstock when turning wood? Doing the horns, you won't have that support. I suppose you could turn the outside diameter using a tailstock center and then put a center rest on the mouth of the horn...

Report message to a moderator

[Message index]

		Lathe turned horn for PSD2002 By: MartinG on Thu, 23 May 2002 04:21
		Re: Lathe turned horn for PSD2002 By: str8aro on Thu, 23 May 2002 07:25
		Re: Lathe turned horn for PSD2002 By: MartinG on Thu, 23 May 2002 08:00
		Wood horns available online By: Wayne Parham on Thu, 23 May 2002 08:46
		Re: Wood horns available online By: MartinG on Thu, 23 May 2002 09:53
		Re: Wood horns available online By: bmar on Thu, 23 May 2002 17:46
		Thanks Bill! By: MartinG on Fri, 24 May 2002 04:34
		Re: Lathe turned horn for PSD2002 By: str8aro on Thu, 23 May 2002 10:13
		Re: Lathe turned horn for PSD2002 By: MartinG on Thu, 23 May 2002 12:31

Previous Topic:	Reverse attenuation and HF comp. networks, active X-over
Next Topic:	For Sale: Eminence Kappa/2002 2-way speakers

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 25 14:50:35 CST 2024