AudioRoundTable.com: Pi Speakers » Lathe turned horn for PSD2002

Home » Sponsored » Pi Speakers » Lathe turned horn for PSD2002

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Lathe turned horn for PSD2002 [message #36584 is a reply to message #36580]

Thu, 23 May 2002 07:25

str8aro
Messages: 12
Registered: May 2009

Chancellor

It wouldn't be too hard if you were already good at lathe work and had a lathe with the capacity for it. If you wanted to make a really deep one you could get into issues with the boring bar needed, but you'd also need a really big lathe so the boring bar probably wouldn't be such a big deal at that point... You do want to make sure you're not overloading the lathe, though. You can burn out bearings and other such fun things.

John

Report message to a moderator

[Message index]

		Lathe turned horn for PSD2002 By: MartinG on Thu, 23 May 2002 04:21
		Re: Lathe turned horn for PSD2002 By: str8aro on Thu, 23 May 2002 07:25
		Re: Lathe turned horn for PSD2002 By: MartinG on Thu, 23 May 2002 08:00
		Wood horns available online By: Wayne Parham on Thu, 23 May 2002 08:46
		Re: Wood horns available online By: MartinG on Thu, 23 May 2002 09:53
		Re: Wood horns available online By: bmar on Thu, 23 May 2002 17:46
		Thanks Bill! By: MartinG on Fri, 24 May 2002 04:34
		Re: Lathe turned horn for PSD2002 By: str8aro on Thu, 23 May 2002 10:13
		Re: Lathe turned horn for PSD2002 By: MartinG on Thu, 23 May 2002 12:31

Previous Topic:	Reverse attenuation and HF comp. networks, active X-over
Next Topic:	For Sale: Eminence Kappa/2002 2-way speakers

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Nov 25 14:25:15 CST 2024