AudioRoundTable.com: Pi Speakers » Horn lens causing 1k bump?

Home » Sponsored » Pi Speakers » Horn lens causing 1k bump?

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Maybe the horn? Microphone? Measurement environment? Could be lots of things. [message #36486 is a reply to message #36477]

Fri, 17 May 2002 08:59

RyanH
Messages: 20
Registered: May 2009

Chancellor

I'll try and take some measurements outside and use 3 different mics. I'll also mount it in the box (when done) and take some measurements. Unfortunately I don't have any other flares I can test with, but I will measure some other speakers with a published curve (non horn, I have some 7" Stryke fiberglass cone woofers) and see if there is a hump there also. Thanks for the info on all the different variables and I'll try and minimize all of them.
--Ryan

Report message to a moderator

[Message index]

		Horn lens causing 1k bump? By: RyanH on Thu, 16 May 2002 21:50
		Maybe the horn? Microphone? Measurement environment? Could be lots of things. By: Wayne Parham on Fri, 17 May 2002 01:49
		Re: Maybe the horn? Microphone? Measurement environment? Could be lots of things. By: RyanH on Fri, 17 May 2002 08:59
		Re: Maybe the horn? Microphone? Measurement environment? Could be lots of things. By: str8aro on Mon, 20 May 2002 13:11

Previous Topic:	4Pi WIDTH, ROOM BOOST AND PORT PLACEMENT?
Next Topic:	I lost my screws! (out of my compression drivers....)

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 22:45:18 CST 2024