AudioRoundTable.com: Pi Speakers » Filling screw holes for Veneer

Home » Sponsored » Pi Speakers » Filling screw holes for Veneer

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Filling screw holes for Veneer (Quick filler) [message #36093 is a reply to message #36071]

Tue, 23 April 2002 20:02

newjerseybt
Messages: 12
Registered: May 2009

Chancellor

In a pinch you can mix fine saw dust (from belt sander) with Elmers
furniture glue. This will not look pretty and will not stain. I am
assuming you will veneer over the screws. Fill over the holes 1/16
of an inch as the mix will shrink when dry. Use a sanding block with 60 grit to level the filler.

Report message to a moderator

[Message index]

		Filling screw holes for Veneer By: bmar on Mon, 22 April 2002 17:32
		Re: Filling screw holes for Veneer By: trancemitr on Tue, 23 April 2002 04:32
		Re: Filling screw holes for Veneer (Quick filler) By: newjerseybt on Tue, 23 April 2002 20:02
		Re: Filling screw holes with Bondo By: pRC on Wed, 24 April 2002 12:14

Previous Topic:	good plywood? bad plywood? I'm the plywood with the gun.
Next Topic:	Madman Wayne, these kit prices are a freakin' steal!

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 20 23:30:19 CDT 2024