AudioRoundTable.com: Pi Speakers » Question for Wayne

Home » Sponsored » Pi Speakers » Question for Wayne

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Baltic Birch Ply or MDF? [message #35987 is a reply to message #35986]

Mon, 15 April 2002 23:04

BobCat
Messages: 18
Registered: May 2009

Chancellor

Wayne,
Thanks for your timely reply to my post! I am wondering if I might substitute Baltic Birch Plywood for the MDF in your kits? Or is this a bad idea? What do you think about using AcoustaStuf or Deflex pads in place of fiberglass stuffing? How much stuffing do you use and where is it placed? What would it cost to ship a pair of completed Two Pi's to Dubuque, Iowa 52003? Last question: what is the "connector panel" you referred to above?
Blessings,
BobCat

Report message to a moderator

[Message index]

		Question for Wayne By: BobCat on Mon, 15 April 2002 18:15
		one π, two π and four π kits By: Wayne Parham on Mon, 15 April 2002 21:22
		Baltic Birch Ply or MDF? By: BobCat on Mon, 15 April 2002 23:04
		Re: Baltic Birch Ply or MDF? By: Wayne Parham on Mon, 15 April 2002 23:56
		pe 260-311 is similar, but mounts in a 3 in. By: Sam P. on Tue, 16 April 2002 06:18
		Re: one π, two π and four π kits By: Edwin on Wed, 17 April 2002 04:12
		Re: one π, two π and four π kits By: Wayne Parham on Wed, 17 April 2002 11:06
		Thanks Wayne (nt) By: Edwin on Wed, 17 April 2002 14:52

Previous Topic:	Speaker Plans
Next Topic:	Active Crossover Designs

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 29 11:47:06 CST 2024