AudioRoundTable.com: Pi Speakers

Home » Sponsored » Pi Speakers » Horn flare survey

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Horn flare survey [message #35948 is a reply to message #35941]

Fri, 12 April 2002 19:10

BillEpstein
Messages: 886
Registered: May 2009

Illuminati (2nd Degree)

I hate the soft plastic of the CH-3; but it looks better on the Theatre without a doubt.
OTOH, it should be easy enough to simulate recessing the 290 with a molding thereby extending it's apparent size.
Make the front baffle three piece: inner 24X36 to mount the horn, mid also 24X36 with a slot cut beyond the outer dimension of the horn far enough to accomodate 3/4 round trim to flare the baffle and finally the 24X ? for whichever manner you choose to recess the woofer.
Any takers?

Report message to a moderator

[Message index]

		Horn flare survey By: Wayne Parham on Fri, 12 April 2002 14:44
		Re: Horn flare survey By: bmar on Fri, 12 April 2002 15:00
		Re: Horn flare survey By: dbeardsl on Fri, 12 April 2002 15:45
		Re: Horn flare survey By: replay on Fri, 12 April 2002 16:50
		H 290 (nt) By: Rex Mills on Fri, 12 April 2002 17:29
		Re: Horn flare survey By: steve f on Fri, 12 April 2002 18:37
		Re: Horn flare survey By: BillEpstein on Fri, 12 April 2002 19:10
		Re: Horn flare survey By: Garland on Sat, 13 April 2002 02:21
		Re: Horn flare survey By: trancemitr on Sat, 13 April 2002 15:01
		Re: Horn flare survey By: boblaz on Sat, 13 April 2002 16:06
		Take 290, stick to Eminence for whole speaker (nt) By: Erik from Holand on Mon, 15 April 2002 00:05
		290 - Same bang, less buck (nt) By: JLapaire on Mon, 15 April 2002 05:48
		Re: Horn flare survey By: Hodel on Mon, 15 April 2002 12:01
		I'm sure Wayne will provide proper bolts By: Sam P. on Mon, 15 April 2002 15:44
		Thanks for all your input! By: Wayne Parham on Tue, 16 April 2002 00:21
		What can be done about the inconsistent bolt holes?(nt) By: Garland on Tue, 16 April 2002 06:49
		Use 1/4"-20 x 3/4" bolts By: Wayne Parham on Tue, 16 April 2002 09:38

Previous Topic:	Wayne, what about the compensation network??
Next Topic:	crossover design... help....

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Dec 01 12:51:57 CST 2024