AudioRoundTable.com: Pi Speakers » Questions on dual 2226 woofer cabinets

Home » Sponsored » Pi Speakers » Questions on dual 2226 woofer cabinets

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: Use an 600-800Hz crossover on the 2446 [message #35314 is a reply to message #35310]

Mon, 04 March 2002 22:56

Wayne Parham
Messages: 18792
Registered: January 2001

Illuminati (33rd Degree)

If you plan to use two woofers, I'd run it as a 2.5-way, with just a large coil on the lower woofer to limit its output to bass only. The upper woofer would be a midwoofer, and it should be connected using the π crossover. Be sure to use a Zobel on the midwoofer to prevent peaking near the crossover frequency.

Report message to a moderator

[Message index]

		Questions on dual 2226 woofer cabinets By: jlharden on Mon, 04 March 2002 12:23
		Re: Here's a link By: BillEpstein on Mon, 04 March 2002 13:41
		Thanks, Bill! By: Wayne Parham on Mon, 04 March 2002 15:11
		Use an 600-800Hz crossover on the 2446 By: Wayne Parham on Mon, 04 March 2002 15:04
		Re: Use an 600-800Hz crossover on the 2446 By: jlharden on Mon, 04 March 2002 17:11
		Re: Use an 600-800Hz crossover on the 2446 By: Wayne Parham on Mon, 04 March 2002 22:56
		Re: Use an 600-800Hz crossover on the 2446 By: jlharden on Tue, 05 March 2002 15:21
		Re: Use an 600-800Hz crossover on the 2446 By: Wayne Parham on Tue, 05 March 2002 20:06

Previous Topic:	Types of distortion to avoid
Next Topic:	Will Pi Come Up with a "Tower" Enclosure?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 04 02:04:43 CST 2024