AudioRoundTable.com: Pi Speakers » VERY easy CH-3 question

Home » Sponsored » Pi Speakers » VERY easy CH-3 question

Fri, 01 March 2002 08:10

trancemitr
Messages: 74
Registered: May 2009

Viscount

1/4" 20 cap screws. I would guess the heads should be about 3/8". Do you think that's big enough?

Kevin

		VERY easy CH-3 question By: trancemitr on Fri, 01 March 2002 07:01
		Re: VERY easy CH-3 question By: Adam on Fri, 01 March 2002 07:57
		I was going to use... By: trancemitr on Fri, 01 March 2002 08:10
		Re: I was going to use...Unfortunately..... By: BillEpstein on Fri, 01 March 2002 13:44
		I've never actually seen.... By: LuxmanLover on Fri, 01 March 2002 14:53
		this project keeps getting more and more complicated (nt) By: trancemitr on Fri, 01 March 2002 16:05
		Re: "Button Head" cap screws are good <nt> By: bmar on Fri, 01 March 2002 20:03
		Re: I was going to use... By: BillEpstein on Sat, 02 March 2002 04:29
		Re: Button Heads By: bmar on Sat, 02 March 2002 11:25
		BMAR, you've done it again! Thanks. nt By: BillEpstein on Sat, 02 March 2002 12:52
		Re: VERY easy CH-3 question By: steve f on Sat, 02 March 2002 06:55

Previous Topic:	Four Pi's -- ports on the inside or outside edge?
Next Topic:	horn cutting adventure, murphy helped too!

Goto Forum:

] [

]

Current Time: Wed Feb 26 02:26:32 CST 2025