AudioRoundTable.com: Pi Speakers » crossover component burn-in:)

Home » Sponsored » Pi Speakers » crossover component burn-in:)

Wed, 27 February 2002 16:24

Adam
Messages: 419
Registered: May 2009

Illuminati (1st Degree)

I just noticed the two woofer discussion. You could try an MTM design, with a woofer above and below the horn.

Adam

		crossover component burn-in:) By: Sam P. on Wed, 27 February 2002 07:00
		1.0 mH too much choke for dual 2226J's? By: Sam P. on Wed, 27 February 2002 09:04
		Multiple point sources and destructive interference By: Wayne Parham on Wed, 27 February 2002 11:31
		imaginary dip/measurement artifact By: Sam P. on Wed, 27 February 2002 15:03
		Re: imaginary dip/measurement artifact By: Wayne Parham on Wed, 27 February 2002 15:45
		Re: imaginary dip/measurement artifact By: Adam on Wed, 27 February 2002 16:24
		diffraction issues again... By: Sam P. on Wed, 27 February 2002 13:43
		Re: diffraction issues again... By: Wayne Parham on Wed, 27 February 2002 16:25
		measurement system DOES suk By: Sam P. on Thu, 28 February 2002 05:23
		screwed by geometry, By: Sam P. on Thu, 28 February 2002 06:40

Previous Topic:	Making sure before I buy
Next Topic:	Pi 2's with Bottlehead Paramour Review

Goto Forum:

] [

]

Current Time: Tue Nov 19 00:20:17 CST 2024