AudioRoundTable.com: Pi Speakers » crossover component burn-in:)

Home » Sponsored » Pi Speakers » crossover component burn-in:)

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: imaginary dip/measurement artifact [message #35255 is a reply to message #35253]

Wed, 27 February 2002 15:45

Wayne Parham
Messages: 18759
Registered: January 2001

Illuminati (33rd Degree)

If there is some reason a 2.5-way system isn't an option, I'd probably cross a dual woofer lower than I would a single woofer. Dual woofer cabinets were really designed to be used as subwoofers. The intended frequency range is below 1/2λ cancellation between drivers. They're usually used with crossovers that limit upper frequency to 100Hz or so.

Report message to a moderator

[Message index]

		crossover component burn-in:) By: Sam P. on Wed, 27 February 2002 07:00
		1.0 mH too much choke for dual 2226J's? By: Sam P. on Wed, 27 February 2002 09:04
		Multiple point sources and destructive interference By: Wayne Parham on Wed, 27 February 2002 11:31
		imaginary dip/measurement artifact By: Sam P. on Wed, 27 February 2002 15:03
		Re: imaginary dip/measurement artifact By: Wayne Parham on Wed, 27 February 2002 15:45
		Re: imaginary dip/measurement artifact By: Adam on Wed, 27 February 2002 16:24
		diffraction issues again... By: Sam P. on Wed, 27 February 2002 13:43
		Re: diffraction issues again... By: Wayne Parham on Wed, 27 February 2002 16:25
		measurement system DOES suk By: Sam P. on Thu, 28 February 2002 05:23
		screwed by geometry, By: Sam P. on Thu, 28 February 2002 06:40

Previous Topic:	Making sure before I buy
Next Topic:	Pi 2's with Bottlehead Paramour Review

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Sep 12 20:20:54 CDT 2024