AudioRoundTable.com: Pi Speakers » Wayne, C5 question again...

Home » Sponsored » Pi Speakers » Wayne, C5 question again...

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

Re: complete xover parts and HF stuff was only [message #35145 is a reply to message #35144]

Sun, 17 February 2002 09:15

Adam
Messages: 419
Registered: May 2009

Illuminati (1st Degree)

Well, the thing is I'm building two pairs, not just one... Otherwise my crossover is very similar to yours (I imagine) other then I'm still using the zobel.

I'll have to find a good combination to get the value. I'll try out some different patterns and see what can get closest to 42.5uF (the actual needed value) while reducing cost.

Adam

Report message to a moderator

[Message index]

		Wayne, C5 question again... By: Adam on Fri, 15 February 2002 11:11
		Re: Wayne, C5 question again... By: Wayne Parham on Fri, 15 February 2002 15:02
		Re: Wayne, C5 question again... By: Adam on Fri, 15 February 2002 15:44
		Re: Wayne, C5 question again... By: Adam on Fri, 15 February 2002 15:45
		complete xover parts and HF stuff was only By: Sam P. on Sun, 17 February 2002 07:34
		Re: complete xover parts and HF stuff was only By: Adam on Sun, 17 February 2002 09:15
		zobels do not require precision By: Sam P. on Sun, 17 February 2002 12:39
		Re: zobels do not require precision By: Adam on Sun, 17 February 2002 13:13
		what about "parts connection" in Ontario?(nt) By: Sam P. on Sun, 17 February 2002 14:14
		Re: what about "parts connection" in Ontario?(nt) By: Adam on Sun, 17 February 2002 15:24
		www.partsconnection.on.ca By: Sam P. on Sun, 17 February 2002 16:07
		new siteis www.partsconnexion.com (nt) By: replay on Mon, 18 February 2002 10:22

Previous Topic:	Are the Alpha 8s and 10s as smooth as their graphs?
Next Topic:	another horn hater www.audioperfectionist.com

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Feb 01 18:41:04 CST 2025