AudioRoundTable.com: Pi Speakers » jbl single 2035H vs. dual 2226J shootout

Home » Sponsored » Pi Speakers » jbl single 2035H vs. dual 2226J shootout

Show: Today's Messages :: Navigator :: Polls
E-mail to friend

4638 system uses parallel wiring, [message #35063 is a reply to message #35062]

Sun, 10 February 2002 07:27

Sam P.
Messages: 307
Registered: May 2009

Grand Master

so the SYSTEM z with two 8 ohm nominal drivers is rated as 4 ohms. I tested sensitivity with a single 2035H, ie one 8 ohm driver, connected to the amp. 2.83 volts, at the driver terminals, into a nominal 8 ohm z. But the v.c. DCR is 3.95 ohms. The 4638 system, with both drivers hooked up, was 2.0 ohms DCR, maybe a tough load for some amps, but who cares cause this one is being chopped up as a "donor" for woofers in my Pseudo 4 Pi Pro rear surrounds. Sam

Report message to a moderator

[Message index]

		jbl single 2035H vs. dual 2226J shootout By: Sam P. on Fri, 08 February 2002 12:15
		Re: jbl single 2035H vs. dual 2226J shootout - did you check Re? By: freddyi on Sat, 09 February 2002 18:20
		4638 system uses parallel wiring, By: Sam P. on Sun, 10 February 2002 07:27

Previous Topic:	Seven Pi-18 or Ten Pi-18(long)
Next Topic:	Re:pi4

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Feb 01 00:56:51 CST 2025